Home Depot makes a Ready Strip deglosser. Cuts the gloss of paint helping to insure proper adhesion for new coatings. Works on most surfaces including wood, plaster, metal, masonry, concrete and fiberglass. Water-based formula is ideal for use indoors and outdoors. Non-corrosive to prevent damage to wood, metal, stone, fiberglass and floors.

Step 7. Replace the finish by brushing or spraying it. Apply one coat, let it dry; scuff it with 220-grit sandpaper, and apply a second coat. Advertisement. Spilling an alcoholic drink on wood often results in a dye stain that you may be able to remove with bleach or by sanding.

Put on protective gloves, protective eyewear, and a respirator. In a well-ventilated area, apply the stripping gel to the wood surface following the manufacturer's instructions. Rather than coat the entire piece, work on designated sections at a time. Allow the stripping gel to sit for 30 minutes to 24 hours depending on the product's directions. Method Number One for Removing Veneer: A Hot Iron with Water. After removing the hardware and giving them a good wipe down, method number one involves WATER. The idea is that moisture gets into the glue and un-sticks it, which allows you to pull up or remove the veneer from the wood more easily. Grab a bucket of lukewarm water and a big old towel.
Rinse with clear water, then gently scrape off any paint spatters with a plastic putty knife. When the wood is dry, dip a rag into the stain and wipe it over the wood. Bare spots and scratches will pick up the stain. Finish by wiping the woodwork with a clean cloth to remove the excess stain.
Wood table: You can use acetone on the wood table if there is any damage or you want to remove the existing finish. Typically, acetone is not safe for wood tables. It might damage the furnishing or bright finishing through the harsh chemical reaction. To remove the paint from the wood table, you can use a mixture of acetone. . 233 599 964 998 374 161 953 583

how to remove finish from wood